Can anyone tell me how to remove the bolt from the CZ 200. I want to replace the O-ring. And if possible can anyone give me the diameters (size) of the O-ring. All help greatly appreciated. Thanks
Do you need to take out the bolt Kleinkoppie? I cant remember now but is the o-ring on the front of the bolt? if it is then you can just use a pin and lift it off and put the new one on. Have done a few on QB's like that.
JTK, yes it's on the front of the bolt. But there is still a 'little' bed that you use to put the pellet on. O-ring size ?
The groove where you load the pellet in bolted down with 2 grub screws. Cock the bolt to the back, remove the little block, change your o-ring and install the little block again. As easy as that.
yes Goose is right. I remember the little block that you need to remove to put the mag conversion in. that will make it very easy using a pin or two
Will try, thanks people. Only need to know the size. I'm not very keen of walking into a shop with the CZ. Police and me and pigeons aren't verx good friends as some of you know...
lol. just take it off and take the o-ring to the shop. they will not know the size just looking at the o-ring on the bolt either. and yes. stay clear of the police.
Mercy Buku to all that helped...
No sweat! Just experience.
pleasure dude.. btw.. the speed of darkness is +- 300000km/s